EP001 is a beginner kit with little or no previous knowledge of electronics. Basic soldering techniques required for circuit board assembly. It comes with two sets of flashing circuit and sound circuit, and soldering tools including a soldering iron, cutting pliers and a soldering base. This will make learning electronics easy and fun! Just follow our manual and build exciting projects. You can even play electronic games with your friends. Enjoy hours of educational fun while learning about electronics.


Key Features:

• A simple two LED flasher
• An ambulance siren
• A soldering iron
• Cutting pliers
• A soldering base

FM Wireless Mic Kit, low voltage, 1 state. This circuit is a coil-type printed in resonance that makes it easy to assemble. 3V. Assembly is required!


Key Features:

• With a coil-type printed resonance circuit ,this FM wireless microphone can be easily assembled 3V.
• Box for product Part #FB08

A condensor microphone that transmits FM radio! The frequency depends on the state of the trimmer and the coils. Runs on 9vDC. Always transmitting when getting power. Adjustable frequency FM! Assembly is required!


Key Features:

• With a coil-type printed resonance circuit ,this FM wireless microphone can be easily assembled 9V.
• Runs on 9vDC. Always transmitting when getting power.
• Adjustable frequency FM!
• Box for product Part #FB08

A condensor mic that transmits to an adjustable FM frequency. This is a two stage version, with two trimmers for optimal frequency adjustments. A neat little circuit. Runs on 9vDC. Assembly is required!

Key Features:

• This electronic circuit is consisting of an extra TR for the RF and two trimmers.
• Power supply 9V.
• Box for product Part #FB08

Additional Information:

• Click here to view the circuit diagram

This mini tuner circuit provides a good training ground for beginners since it consists of very few essential parts but enough to make a complete tuner. Assembly is required!


Key Features:

• Tuner is radio receives that receiver signal from radio station sent signal to out.
• This tuner circuit is a mini radio receiver.
• Power supply 9V.
• Box for product Part #FB03

This AM receiver circuit relies on the use of IC without IF or OSC coils to keep the number of parts to minimum. 4.5-9V power supply requirement. Assembly is required!


Key Features:

• This AM Radio receiver circuit consists of a few components so it is very easy to assemble.
• Power supply 6V.
• Box for product Part #FB04

A basic and low cost AM radio circuit for educational purposes and beginners. Assembly is required!


Key Features:

• This Am simplify radio circuit is a saving circuit that requires few components and suitable for educational use.
• Power supply 3V.
• Box for product Part #FB03

With approximately 150 mW the circuit can provide an operational range of 50-150M.With a maximum transmission of 1W,this Walky-Talky set is allowed for general public. Assembly is required!


Key Features:

• With approximately 150mW. the circuit can provide an operational range of 50-150 m.
• With maximum transmission of 1 W this walky-talky set is allowed for general public.
• Power supply 9V.
• Box for product Part #FB07

Additional Information:

• Click here to view the circuit diagram

The AM experimental board circuit is a superheterodyne reception consisting of converter, IF section, and OTL amplifier. A basic circuit and valuable device for educational purpose. Assembly is required!


Key Features:

• A basic circuit consisting of converter, if and amplifier of OTL type.
• It is a valuable device for educational purpose.
• Power supply 6V.

Additional Information:

• Click here to view the circuit diagram